Ikonart TriggerJet Brass Nozzle + Inlet | Increase Washout Pressure | 3/4" Garden Hose Fitting
Faster washout with higher quality using less water.
Ikonart USASKU: E-IASPRAY
Speeds Washout - Less Water with Higher Pressure
The TriggerJet Nozzle is a pressure spray nozzle with a flat spray trajectory that can be used with a standard garden hose connection for washing out your Ikonart/ EZIscreen Films.
If you have a laundry sink in your house or if you are able to get a hose adapter for your kitchen/bathroom tap, the TriggerJet Nozzle can make washing out your Films much faster compared to using a standard kitchen sink sprayer with lower pressure.
This nozzle can simulate the equivalent of approximately 150 PSI (10 bar), with less water used at higher pressure, the Ikonart/ EZIscreen Film emulsion will be removed faster.
Pro Nozzle Quality
Made in the USA by Spraying Systems Co, a major supplier to the industrial and car wash sector, this isn't a cheap Bunnings nozzle, it's professionally constructed from durable polypropylene with an ergonomic handheld design.
Unlike cheap plastic garden hoses and nozzels, both ends of the TriggerJet are professional grade brass, built to last:
- a brass flat nozzle connector that can be adjusted for spray angle also removed and cleaned.
- durable brass 3/4" (Garden Hose size fitting) inlet connector with rubber seal fitted.
Hooking Up Your TriggerJet Nozzle
You will need to use a tap adapter and hose with this TriggerJet Nozzle. The adapter will depend on what tap size you are trying to attach the nozzle to.
Here are equivalent products used in the video below - Y Tap Adapter (Bunnings) | Hose (Amazon) | Tap adapter set (Amazon) you can check them out then take the info to your local store, or search similar products on ebay/ your preferred online sites. These items are not stocked by SCREEN PRINTING SHOP.
Film Washout Guide
Quick video showing how to use the TriggerJet and washout your Ikonart/ EZIscreen Films.
Don't Soak Films like StencilPro
Remember less water for washout is better with Ikonart/ EZIscreen. Unlink the previous systems using StencilPro film (now discontinued), which required a 10minute water soaking prior to washout, the new films must not be soaked, sprayed only.
- High pressure washout (approximates 150 PSI)
- Increases the pressure of your water
- Flat spray for faster washout
- Ergonomic handheld design
| SKU | E-IASPRAY |
| Barcode # | 9334315037651 |
| Brand | Ikonart USA |
| Shipping Weight | 0.1600kg |
| Shipping Width | 0.220m |
| Shipping Height | 0.040m |
| Shipping Length | 0.070m |
| Shipping Cubic | 0.000616000m3 |
| Unit Of Measure | Pack |
| Type | Made in USA |
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law (ACL). You are entitled to a replacement or refund for a major failure. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Should you receive a product that does not meet your expectations, you may immediately return it for a refund or exchange - prior to opening or using the product.
Where products have been opened or used, suitability of usage has been determined and no refund is available for change of mind purchases on used products. This does not exclude warranty claims where product may be faulty or contain a manufacturing fault.
