Frame Hinge Clamp | Provides accurate print registration | Off Contact/ Elevated Printing Applications | 50mm Frame Opening

Print registration and elevated/ off contact printing.

NEHOCSKU: SPJ-H1


Metal hinge clamp is a low cost entry to hold your frame, or elevated/ off contact printing applications. Fast butterfly locking for metal & plastic frames, easy mounting using screws. Recommended 2 hinges used for best print registration.

$10.78

RRP $12.95
SAVE $2.17
In Stock

In Stock

Butterfly hinge clamp is a low cost entry into print registration using a hinge to hold your frame, or elevated/ off contact printing applications.

Metal frame inside Jig Hinge Clamps for direct printing

- Suitable for both off contact or direct printing applications
- 45mm clamp width, 50mm maximum opening
- Suitable for all frame sizes/ types, including plastic and metal frames
- Compact size, light weight & portable for easy storage when not in use.

This is a single piece, also available in a set of 2, with easy mounting to almost any surface by screws, bolt or clamp.
- Use of 2 hinges is recommended for elevated/ off contact printing applications for better frame holding where more movement is likely during printing.

Using Metal Frames

Metal Frame mount fit directly into the clamp for direct printing, without need for spacers on top.

When printing items elevated/ off contact, plastic height adjusters are inserted under the metal frame to raise to the required height for printing.

Download instruction guide for registering single colour prints here . .

Download details for setting up a screen for elevated/ off contact printing here . .

Plastic frame inside Jig Hinge Clamps for direct printingUsing Plastic Frames

The thinner construction of plastic frames requires plastic height adjusters to be placed on top of the frame to achieve tight bond, as pictured right.
- A metal/ wooden block or similar object may also be used.

Plastic frames are best suited for direct printing applications.

The flexible construction of plastic frames does not suit elevated printing unless all sides of the frame are supported to stop flexing whilst printing. We recommend using Metal Frames for elevated/ off contact printing applications.

Download instruction guide for registering single colour prints here . .

Print Registration

Jig Hinges hold only one frame at a time for single colour printing. Multiple colour printing is available using registration marks for separate prints overlaying the new colour on top of the previous. This is suitable for solid objects and items that will not resize during movement.
- This process is not recommended for fabrics as too much movement will occur - unless second print/ layer is not close and accurate registration is required.
- For accurate multi layered registration a jig/ carousel is recommend.

Quantity: Each
Max Frame Width: 50mm (45mm recommended)

SKU SPJ-H1
Barcode # 9334315020738
Brand NEHOC
Shipping Weight 0.2500kg
Shipping Width 0.100m
Shipping Height 0.100m
Shipping Length 0.080m
Shipping Cubic 0.000800000m3
Unit Of Measure ea
Type Single Hinge

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law (ACL). You are entitled to a replacement or refund for a major failure. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

Should you receive a product that does not meet your expectations, you may return it for a refund or exchange - prior to opening or using the product.

Where products have been opened or used, suitability of usage has been determined and no refund is available for change of mind purchases on used products. This does not exclude warranty claims where product may be faulty or contain a manufacturing fault. Further support available in the Warranty Support section of this website.

Calculate Shipping